Install the clothes dryer according to the manufacturer’s instructions and local codes.IMPORTANT – Observe all governing codes and ordinances. IMPORTANT – Save these instructions for local electrical inspector’s use. FOR GAS DRYERS ONLY BEFORE YOU BEGIN Read these instructions completely and carefully. A flexible gas connector, when used, must not exceed 4 feet.If using a ball valve, it shall be a T-handle type.Installation must be performed by a qualified or licensed contractor, plumber, or gasfitter qualified or licensed by the State.(Installers: Be sure to leave these instructions with the customer.) In the Commonwealth of Massachusetts, the following installation instructions apply: To reduce the risk of severe injury or death, follow all installation instructions.DO NOT install or store this appliance in any location where it could be exposed to water or weather.These conditions will obstruct dryer airflow and increase the risk of fire.

Flexible venting materials are known to collapse, be easily crushed and trap lint. If flexible metal (semi-rigid or foil-type) duct is installed, it must be UL-listed and installed in accordance with the instructions found in “Connecting the Dryer to House Vent” later in this manual.